FAQ

The system is installed but the retest is still above 4. Now what?

Direct answer

Call the installer with the verification report in hand; the workmanship warranty covers correction. Usual fixes are a second suction point, a stronger fan, or sealing the leaks the first pass missed. The house is diagnosable, not hopeless.

More detail

Start by trusting the number, because in Iowa it deserves trust: the verification test came from a firm with no stake in the install, under normal house conditions, so the result is evidence rather than opinion. Then let the diagnosis run its order. Tight Des Moines lobe till is the most common culprit, limiting how far the original suction point's field extends; pressure readings at small test holes across the slab map the dead zones, and a second point placed in one usually finishes the job. Air leaks are next, a sump lid seeping, a floor-wall joint only partly sealed, each letting the fan waste its suction on basement air. Separate slab pours, footings mid-floor, and a forgotten crawl under an addition each wall off territory the pipe never reached. An upgraded fan is the last resort, not the first, since more suction through a bad layout mostly makes noise. Correction falls under the warranty conversation, and the recheck is another independent test. The quote-stage prevention is covered in comparing Des Moines quotes.

Authoritative sources

Ready to get started?

The Iowa Radon Survey found 71. Mon-Sat 8am-7pm.

Call (515) 642-3364Text us

Prefer to text? Open your texting app