Des Moines and central Iowa

Radon Mitigation Systems in Altoona, IA

Active sub-slab depressurization for central Iowa basements, slabs, and walkouts, installed by Iowa-certified mitigation pros.

Des Moines Radon Pros trust signals

Radon Mitigation Systems in Altoona

About AltoonaNewer plats east of Highway 65 mitigate from one point; the older rail-stop core near Adventureland holds ranches on block walls where the floor-wall joint and sump basket set the sealing scope.

An active sub-slab system sized to the house in front of it: a full basement in Beaverdale, a walkout in Johnston, a split-foyer in Urbandale, or a slab villa in Altoona. Iowa Code chapter 136B requires certification through Iowa HHS for anyone who mitigates radon for a fee, and every install here is performed by a certified mitigation professional. The verification test that follows comes from someone outside the installer's firm, which is how Iowa separates the grade from the graded. Altoona sits within our service area for Des Moines and central Iowa, with same-week scheduling typical for routine jobs.

Typical pricing in Altoona

$1,200-$2,500

Pricing varies by job specifics. Free phone or on-site quotes; fixed pricing once the technician has assessed the job.

Radon Mitigation Systems in Altoona: an older rail-stop core beside Adventureland, with steady eastside subdivision growth since the 1990s foundations and Des Moines lobe glacial till

Altoona pairs a modest pre-1970 core with plat after plat of 1990s-2020s growth east of Highway 65. The newer streets are poured basements and the occasional slab-on-grade villa, both straightforward to treat from one suction point. The older blocks near the rail line hold ranches and story-and-a-halfs on block walls, where the floor-wall joint, the sump, and old floor patches are the usual entry routes worth sealing before the fan goes in. Altoona sits on the Des Moines lobe, glacial till and wind-blown loess ground from uranium-bearing Canadian Shield rock, the reason Iowa leads the country in homes above the action level. Polk County is EPA Zone 1, the highest radon potential rating.

Altoona installs follow the town's two halves. In the older streets near the rail line, a block-wall ranch gets its floor-wall joint and sump sealed, then a cored suction point and a pipe up the side of the house. East of Highway 65, a poured basement or a slab-on-grade villa takes one suction point with the fan in the garage attic. On villas with no basement, the core goes through a closet or utility room floor.

Iowa mitigation work falls under 641 IAC chapter 44 and the ANSI/AARST SGM-SF-2023 standard for existing homes, and the clearance test after an install comes from someone outside the installer's firm, or the homeowner. The Iowa HHS radon program oversees radon program compliance for Altoona, and Iowa law (Iowa Code chapter 136B) requires Iowa HHS certification for anyone testing or mitigating for a fee, with the post-mitigation test run by someone outside the installer's firm or by the homeowner.

County
Polk, IA
Geology
Des Moines lobe glacial till and loess
EPA action level
4.0 pCi/L on long-term average
Service category
Mitigation

Altoona at a glance

County
Polk, IA
Coverage
Same-week scheduling

Authoritative sources

Ready to get started?

The Iowa Radon Survey found 71. Mon-Sat 8am-7pm.

Call (515) 642-3364Text us

Prefer to text? Open your texting app