Active vs Passive Radon Systems
Central Iowa's building boom made this a live question in thousands of houses: newer homes in Ankeny, Waukee, Grimes, and Norwalk often come with a capped pipe rising from the slab to the attic, a passive radon rough-in, while the fix a high test actually calls for is an active system with a fan. The two share plumbing and differ in physics. Passive relies on warm air's natural tendency to rise up the pipe; active puts a continuously running fan on it and makes the pressure difference a certainty instead of a hope.
Active vs Passive Radon Systems
Central Iowa's building boom made this a live question in thousands of houses: newer homes in Ankeny, Waukee, Grimes, and Norwalk often come with a capped pipe rising from the slab to the attic, a passive radon rough-in, while the fix a high test actually calls for is an active system with a fan. The two share plumbing and differ in physics. Passive relies on warm air's natural tendency to rise up the pipe; active puts a continuously running fan on it and makes the pressure difference a certainty instead of a hope.
| Feature | Passive (stub-up, no fan) The builder's head start | Active (fan-driven) The fix a high test calls for |
|---|---|---|
| How it moves gas | Natural stack effect: warm air drifting up the pipe | An inline fan running continuously, holding the soil below house pressure |
| Typical reduction | Modest and weather-dependent; the EPA ranks passive approaches well below fan-driven ones | 50 to 99 percent in the EPA's Consumer's Guide figures |
| Where you find it | Newer construction across the metro's growth towns, as a capped pipe in a utility room or garage wall | Any house that tested high and got fixed, old stock or new |
| Running cost | None | A few dollars a month of fan electricity, plus a fan replacement every five-plus years |
| Noise | Silent | A faint airflow sound; fans sit in the attic or outdoors, never in living space |
| Monitoring | Nothing to monitor and no gauge, which also means no warning | A manometer marked at start-up shows at a glance that suction holds |
| Upgrade path | Adding a fan converts it to active, typically $650 to $1,100 since the routing exists | Already there; service is fan swaps and seal upkeep |
| What Iowa requires after install | Nothing, because nothing was installed; testing is still on you | A post-mitigation test from someone outside the installer's firm |
Our recommendation
Treat a passive stub-up as a discount coupon, not a safety system. Test the house first, every house, stub-up or not: below the action level, enjoy the silence and retest in two years; at 4 pCi/L or above, activate the pipe with a fan and let the independent verification test confirm the result. In a brand-new house, run the first test during your first heating season, when the house reads highest. The one mistake to avoid is the comfortable middle: assuming the capped pipe is protecting anyone. Until a fan runs on it, it is plumbing waiting for a decision.
Ready to get started?
The Iowa Radon Survey found 71. Mon-Sat 8am-7pm.